Leprecon VX Series Dimmer - Manual (Page 8)

8
4.1.2. Setting Non-dim channels - VX Model Only
Non-dim channels switch from full off to full on without any intermediate dimming. This can be
useful for connecting devices that do not dim well, such as some types of motors or transformer
controlled fixtures.
There are two ways to set a channel on-dim channel:
1) Set a single channel by setting the DMX code shown below, and press ‘enter’.
DMX Function
801 Channel 1 Non-dim
802 Channel 2 Non-dim
803 Channel 3 Non-dim
804 Channel 4 Non-dim
805 Channel 5 Non-dim
806 Channel 6 Non-dim
807 Channel 7 Non-dim
808 Channel 8 Non-dim
809 Channel 9 Non-dim
810 Channel 10 Non-dim
811 Channel 11 Non-dim
812 Channel 12 Non-dim
To reset all channels back to normal operation:
Set 899 on the thumbwheel and press ‘enter’ or ‘reset’.
2) Set several channels at once.
•
Connect a functioning console to the VX dimmer.
•
Set the DMX address to 800.
•
Channels with levels above 10% will be programmed as non-dim. The settings are memorized
when ‘enter is pressed.
To reset all channels back to normal operation:
Setting 899 and pressing ‘enter’ or ‘reset’ clears all non-dim channels.