Installation and operating instructions, Description, Front panel layout of apr-1 – Louroe Electronics ASK-4 401 User Manual

Page 2

Advertising
background image

N

I

E

D

U

A

SA

M

+12 Vdc

INPUT

OUTPUT

AUDIO

B

A

C

MIC INPUT

VAN NUYS, CA

[10]

[11] [12]

[13]

REAR

[11] AUDIO-IN Jack (RCA)

Accepts audio playback from DVR/VCR, etc. Audio is produced through the speaker.
The Push for Playback Switch [7] must be IN during audiolayback.

[12] AUDIO-OUT Jack (RCA) Provides audio output and connection to a DVR, VCR, etc.

[13] Audio Terminal Block

A 3-pin terminal block marked A, B and C.
Accepts wiring from remote Verifact™ A Microphone.

A = +12Vdc Power (red wire)
B = Audio (black wire)
C = Ground (bare wire)

INSTALLATION AND OPERATING INSTRUCTIONS

Page 2 of 8

LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406

TEL (818) 994-6498

FAX

994-6458

website: www.louroe.com e-mail: [email protected]

(818)

®

[1] Power-Volume

Turns “ON” power to the unit and controls the audio volume

through the Speaker[9].

[2]

Power Indicator

Lights (green) when the power is present to the unit.

[3]

Mute Indicator

Lights (orange) when Mute Switch[6] is pushed in. Audio is muted.

[4] Playback Indicator

Lights (yellow) when Push for Playback[7] is pushed in to “ON” position.

[5] Overload Indicator Flashes (red) when there is a short in the power supply.

[6] Mute Switch

Used to mute the audio on both live and playback mode.

[7] Push for playback

Used for DVR/VCR playback. May also be used to listen to audio from an

external source. Press switch to listen to playback. Switch must be “OUT”
or “OFF” when monitoring and recording, otherwise live audio is muted.

[8] Headphone Jack

Used for private listening. Any 3.5mm stereo headphone with 8W

to

600W

impedance can be used.

[9] Speaker (3”) Provides live audio. Muted when a headphone is connected to

Headphone Jack [8].

[10] Power Jack

Connects to 12Vdc power supply

DESCRIPTION

THE APR-1 IS SHOWN BELOW. ALL CONTROLS ARE LOCATED AT THE FRONT PANEL. ALL CONNECTIONS ARE
MADE AT THE REAR PANEL.

FRONT PANEL LAYOUT OF APR-1

APR-1

MUTE

PUSH FOR
PLAYBACK

PWR

MUTE

PLAYBACK

OVERLOAD

SINGLE

ZONE

AUDIO

BASE

STATION

OFF

MAX

POWER-VOLUME

[3]

[4]

[5]

[1]

[2]

[6]

[7]

[8]

[9]

TM

Ask4_401_inst_2/15

Advertising