Louroe Electronics DG-12II - Manual (Page 12)

PAGE 9 of 28
Level Control[31] on the front of the DG-MA.
INSTALLATION-Mechanical:
The DG-12II and DG-MA units mount to a 19” wide equipment rack. They should be
located away from extreme dampness or heat to ensure long life and reduce
maintenance requirements. Adequate space should be provided around the units when
placed inside the rack to prevent heat build-up due to poor air circulation. The air must
be vented out of the cabinet. The fan's filter filament should be taken out of the guard
and cleaned with warm water after 3 months and replaced every six months. The filer
filament should be cleaned with warm water after 3 months and replaced every six
months. The filter filament should be cleaned more often when subjected to dust or dirt.
Additional filter filaments can be obtained from Louroe Electronics. (Part #28-0074-1).
INSTALLATION-Electrical:
All electrical installations are made at the rear of the unit.
DG_12II_6/11
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818) ®
INSTALLATION AND OPERATING INSTRUCTIONS