Lynx Studio LT-TB Thunderbolt User Manual
Page 45
45
3.
In the Audio playback software, set the audio configuration settings for 5.1, multi-
channel, or whatever mode is applicable to playing the multi-channel content.
4.
The speaker configuration for surround sound content will be as such:
Channel Name
5.1 Output
7.1 Output
Front Left
1
1
Front Right
2
2
Front Center
3
3
Sub (LFE)
4
4
Surround Left
5
5
Surround Right
6
6
Aux Left
N/A
7
Aux Right
N/A
8
Multi-Channel Interleaved recording is also supported by the driver. To set this up, choose
the Recording tab of the Sound Section of Control Panel. Choose Aurora Record 1+2, then
click on the “Configure” button. Set the Record Mode to the multi-channel configuration that
you desire (includes bit-depth and sample rate) and then click “OK”. As an example, let’s say
you selected 5.1, 24-but, 44.1k.
Now if you open up recording software capable of recording multi-channel streams (Lynx
demo can!), then you could record signals from Aurora Analog Inputs 1-6 into a single,
multi-channel file.
8.3.1.3 ASIO Applications
When using an application that supports the ASIO driver standard, one must specify the
Lynx ASIO driver as the active audio device from within the audio software. Once that is
established, multiple stereo input and output devices will be available for use within the
application. Please note: the channel mode selected for the Aurora will determine the type
and number of I/O devices available, but within ASIO they will always be presented as
multiple stereo devices.
When using an ASIO compatible program, the appropriate ASIO device must be selected
from a settings or options menu in the application. The correct choice would be “Lynx
ASIO”
Many ASIO applications provide access to an ASIO Control Panel for the device being used.
For an LT-TB equipped Aurora, this button will launch the Lynx ASIO Control Panel.
From this panel, the ASIO buffer size and system latency can be
established conveniently within the audio software application.
The following parameters can be altered from the Lynx ASIO
Control Panel:
1. Buffer Size - This control allows the size of the ASIO buffer
in samples to be established. The buffer size is the primary factor