Marantz PM6005 - Manual (Page 31)

31
Appendix Tips Playback Connections Contents
Front panel Rear panel Index Remote
Settings
When three of these units are used in the same location, each unit can be
controlled independently by setting separate remote control codes.
Be sure to check the operation of each unit after setting the remote
control codes.
The default setting is “AMP1”.
ENTER
REMOTE MODE
CD
1 – 3
Setting remote control codes for the
remote control
2 To set the remote control codes to AMP2
1 Press and hold REMOTE MODE CD and number button
2 for 5 seconds or longer.
2 To set the remote control codes to AMP3
1 Press and hold REMOTE MODE CD and number button
3 for 5 seconds or longer.
NOTE
• To restore the remote control code default setting, press and hold REMOTE MODE
CD and number button 1 for 5 seconds or longer.
• The remote control codes returns to the default settings when the batteries are
removed. Set the remote control codes again after replacing the batteries.
Setting remote control codes