Connecting a external power amplifier, Cables used for connections – Marantz SR5005 User Manual
Page 26
20
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
ESPAÑOL
NEDERLANDS
SVENSKA
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
ESPAÑOL
NEDERLANDS
SVENSKA
Connect a device that has a multichannel output
terminal
• You can connect this unit to an external device fitted with multi-channel sound audio output jacks to enjoy
music and video.
• The video signal can be connected in the same way as a Blu-ray Disc player / DVD player (vpage 16
“Connecting a Blu-ray Disc player / DVD player”).
Cables used for connections
Audio cable (sold separately)
Audio cable
(White)
(Red)
R
L
R
L
Audio cable
R
L
R
L
R
L
R
L
R
L
R
L
SUB-
WOOFER
CENTER
SURROUND
BACK
R
L
SURROUND
R
L
FRONT
R
L
AUDIO
Blu-ray Disc player / DVD player /
External decoder
To play analog signals input from 7.1CH INPUT terminals, set “Input Mode” (vpage 49) to “7.1CH
INPUT”.
“7.1CH INPUT” can also be selected with
A/D
on the remote control unit.
in Set as Necessary
When a device is connected to the SBL/SBR terminal of 7.1CH INPUT terminals, set “Amp Assign”
(vpage 54) to “Normal”.
Connecting a external power amplifier
• You can use this unit as a pre-amp by connecting a commercially available power amp to the PRE OUT
connector. Adding a power amp to each of the channels provides an even greater sound presence.
• Select the connector to use and connect the device.
Cables used for connections
Audio cable (sold separately)
Audio cable
(White)
(Red)
R
L
R
L
Audio cable
R
L
R
L
R
L
R
L
R
L
R
L
SUB-
WOOFER
CENTER
SURROUND
BACK
R
L
SURROUND
R
L
FRONT
R
L
AUDIO
Power amplifier
• When using just one surround back speaker, connect it to the left channel (L) terminal.
• Use the volume control on the subwoofer to control subwoofer volume.
• If the subwoofer volume sounds low, use the volume control provided on the subwoofer to adjust the
volume.
NOTE
• When speakers have been connected to PRE OUT terminals, do not connect the speakers to the speaker
terminals.
• The output channels for the PRE OUT connector change to SBL and SBR in the “Amp Assign” (vpage 54)
settings in the menu.