Mathey Dearman Mini Jolli Chain Machine - Manual (Page 8)

7
FIGURE 1
4.4.2 Form all sections of the guide strip so that they fit the pipe diameter to be cut as close as possible.
The better the sections of the guide strip fit the diameter of the pipe; the easier it will be to adjust
and latch the ends of the guide strip together.
FIGURE 2
4.4.3
Attach the sections of the guide strips together as shown in Figure 2 and insert the pins (C2).
4.4.4 The section containing the latch handle assemblies (Figure 1 item B) should be at one end of the
fully assembled guide strip and the section containing the receiver section ends (Figure 1 item A)
should be at the other end.
4.4.5 It may be necessary to move the latch handle assembly along the holes in the latch section in
order to latch the guide strips to fit tightly around the pipe circumference. To move the latch
handle assembly to the proper location; remove the counter screws and domed nuts (Figure 1 Item
D) from the latch handle assemblies (Figure 1 Item B).
4.4.7 Locate the nearest holes (Figure 1 item G) in that section of the guide strip and mark them.
4.4.8 Place the latch handle assemblies (Figure 1 item B) base over the marked holes and insert
countersunk screws and nuts (Figure 1 item D) in the latch handle assembly base.
Warning: Do not place the machine on the portion of the pipe that is being
cut off, this will result in serious injury to the operator and unrepairable
damage to the Mini Jolli Chain Machine.