Maytag M8TXEGFBS - Manual (Page 9)

9
4. Slide the handle upward to release it from the keyhole slot
and pull the handle away from the door.
5. Remove the decal covering the hole on the opposite side of
the door, where the refrigerator door handle will be installed,
and discard the decal.
6. Remove the shoulder screw from the left-hand side of the
door and fasten it into the hole in the door that was behind
the decal.
7. Align the keyhole slot in the handle mounting bracket with the
shoulder screw. Position the handle so that the mounting
base is flush against the door. Slide the handle downward
until it locks into place.
8. Fasten the top of the refrigerator handle to the top of the
refrigerator door.
9. Cover the remaining hole with the decal (provided).
10. Tighten all screws. Set aside refrigerator door until bottom
hinge is installed on the opposite side of the refrigerator.
NOTE: For 21 cu ft models, transfer both the bottom hinge
assembly and the leveling foot to the opposite side.
Reverse Top Hinge
1. Remove the screw attaching the hinge pin to the hinge. Turn
the hinge over so that it is pointing in the opposite direction.
2. Place the plastic spacer beneath the hinge so that it will be
between the hinge and the cabinet, making sure the holes are
aligned.
3. Fasten the Top Hinge to the opposite side of the cabinet,
inserting the screws only halfway, so you will be able to
replace and align the freezer door later.
A. Flat-head handle screws B. Refrigerator door handle
A. Flat-head handle screws B. Refrigerator door handle
A
B
A
B
A. Flat-head handle screws
A. Plastic spacer
B. Hinge pin screw C. Hinge pin
A.
⁵⁄₁₆
" Hex head hinge screws
B. Top hinge pin
C. Plastic spacer
A
A
B
C
A
B
C
A
B
C