Maytag MDBH970AWB Installation - Manual (Page 2)

Installation Instructions
B u i l t - I n D i s h w a s h e r
Leave Installation Instructions and User’s Guide with Owner
ALL ELECTRICAL WIRING, GROUNDING AND PLUMBING
SHOULD BE DONE IN ACCORDANCE WITH NATIONAL
AND LOCAL CODES BY QUALIFIED INDIVIDUALS.
G R O U N D I N G I N S T R U C T I O N S
This appliance must be connected to
a grounded metal, permanent wiring
system; or an equipment-grounding
conductor must be run with the
circuit conductors and connected to
the equipment-grounding
terminal or lead on the appliance.
P L U M B I N G R E Q U I R E M E N T S
CHECK LOCAL PLUMBING CODES
FOR APPROVED PLUMBING
PROCEDURES AND ACCESSORIES.
ALL PLUMBING SHOULD BE DONE
IN ACCORDANCE WITH NATIONAL
AND LOCAL CODES.
E L E C T R I C A L R E Q U I R E M E N T S
WARNING
To prevent the possibility of electrical shock, this
dishwasher, as other electrical appliances, must be
adequately grounded. It is the responsibility of the installer
at the point of installation, taking into consideration local
conditions and requirements. Failure to follow this warning
could result in death or serious injury.
Disconnect electrical power to
dishwasher before you start!
Failure to follow this warning could
result in death or serious injury.
WARNING
WARNING
This dishwasher is designed for
operation on an individual 120 VAC,
60 Hz grounded electrical circuit. Use
required fuse (15 amp) or comparable
circuit breaker. Two wire with ground
service to the dishwasher is
recommended for connection at the
terminal box for grounding.
To prevent accidental contact with electrical connections,
built-in dishwasher models must not be connected to a
power source unless the dishwasher is completely enclosed,
with front panels in place. If the back or either side of the
dishwasher is exposed, a panel must be used to complete
this enclosure. Failure to follow this warning could result in
death or serious injury.