MBM Corporation OMR - Manual (Page 3)

T09137
Page 3
1. Remove the screws (1) fastening the reinforcement bar.
2. Install the sliding bar (2) using new (longer) screws (3) and washers (4) placed
between the sliding bar and the reinforcement bar (fig 1).
3. Loosen the knob (5) on the reader head. Place the reader head on the sliding bar and
tighten the knob (fig 2).
4. Clean the surface where wiring covers (6) will be installed.
5. Remove protective strip from wiring cover and install according to illustration below.
1
1
5
6
3
4
2
fig1. fig 2.