MBM Corporation TRIUMPH 5222 DIGICUT - Manual (Page 19)

-19 -
5222 DIGICUT
Start machine
• Main switch F to position "I", insert the key H
for the control panel and turn it to the right.
• Press S button Q backgauge I moves
to the rear and searches for the reference
position, wait until a measurement is shown
in the display D (52 cm or 20,47 inches).
Warning!
Before storing or cutting a measurement please
check if the correct measurement scale (cm or
inch) is stored (LED lights). For information on
how to store see picture below left.
Cutting to specified dimensions
• Enter dimension on the numerical key pad S
LED "S" Z lights.
(If a wrong dimension is entered this can be
corrected by pressing the s button).
• Press S button dimension is approached,
LED "S" disappears.
With the false clamp measurements between
7 cm and 9 cm can only be approached with
the hand-wheel G . See page 16.
• Insert paper and move by means of the
stacking angle to the backgauge I and side
lay on the left J .
• Release the cut.
Cut according to markings
• Adjust the backgauge with the hand-wheel or
crank handle G to the back.
• Insert paper and move by means of the
stacking angle b to the backgauge I and
side lay on the left J .
• Turn the hand-wheel G to the right until the
marking on the paper to be cut is below the
cutting line indicator.
• The further the hand-wheel G is turned to the
right, the quicker the backgauge moves. If the
hand-wheel is turned to the left the
backgauge will return quicker.
• Release the cut.
• Operation •