McCall MCCR1-G - Manual (Page 25)


McCall
Standard Labor Guidelines To Repair Or Replace Parts On McCall Equipment
Advice and recommendations given by McCall Service Technicians do not constitute or guarantee any special coverage.
• A maximum of 1-hour is allowed to diagnose a defective component.
• A maximum of 1-hour is allowed for retrieval of parts not in stock.
• A maximum travel distance of 100 miles round trip and 2-hours will be reimbursed.
• Overtime, installation/start-up, normal control adjustments, general maintenance, glass breakage, freight damage, and/or
correcting and end-user installation error will not be reimbursed under warranty unless pre-approved with a Service Work
Authorization from McCall. You must submit the number with the service claim.
Labor Of 1-Hour Is Allowed To Replace:
• Thermostat • Contactor/Relay
• Door Jamb Switch • Evaporator/Condenser Fan Motor and Blade
• Solenoid Coil • Circulating Fan Motor and Blade
• Hi-limit/Thermal Protector Switch • Microprocessor Control
• Fan Delay/Defrost Termination Switch • Transformer
• Compressor Start Components and Overload Protector • Door Hinges, Locks, and Gaskets
• Defrost Timer • Condensate Element
• Thermometer
Labor Of 2 Hours To Replace:
• Drawer Tracks/Cartridges
• Defrost Element
• Pressure Control • Heating Element
• Solenoid Valve • Locate/Repair Leak
Labor Of 3 Hours To Replace:
• EPR or CPR Valve
• Condenser or Evaporator Coil
• Expansion Valve
Labor Of 4 Hours To Replace:
• Compressor
This includes recovery of refrigerant and leak check.
$55.00 maximum reimbursement for refrigerant recovery (includes recovery machine, pump, torch, oil, flux, minor fittings,
solder, brazing rod, nitrogen, or similar fees.)
Refrigerants:
• R404A A maximum of $15.00/lb. or $1.00/oz. will be reimbursed.