Measurement Computing USB-2627 - Manual (Page 8)

8
Chapter 2
Installing the USB-2627
What comes with your shipment?
Verify that the following hardware components are included in the shipment:
Hardware
 USB-2627 (with standoffs)
 USB cable
Software
 MCC DAQ CD
Documentation
 MCC DAQ Quick Start Guide
The Quick Start Guide booklet provides an overview of the MCC DAQ software you received with the
device, and includes information about installing the software. Please read this booklet completely before
installing any software or hardware.
Optional components
 Cables
o CA-68-3R
o C40FF-x
 Signal termination boards
o TB-100
o TB-103
o CIO-MINI40
Unpacking
As with any electronic device, you should take care while handling to avoid damage from static
electricity. Before removing the USB-2627 from its packaging, ground yourself using a wrist strap or by simply
touching the computer chassis or other grounded object to eliminate any stored static charge.
If any components are missing or damaged, contact us immediately using one of the following methods:
 Knowledgebase: kb.mccdaq.com
 Phone: 508-946-5100 and follow the instructions for reaching Tech Support
 Fax: 508-946-9500 to the attention of Tech Support
 Email:
[email protected]
For international customers, contact your local distributor. Refer to the International Distributors section on our
website at
www.mccdaq.com/International .
Installing the software
Refer to the Quick Start Guide for instructions on installing the software on the MCC DAQ CD. This booklet is
available at
www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf .