3 - command descriptions, 1 introduction, 1 introduction…… 3-1 – Measurement Computing Micro488/p User Manual
Page 19: Command descriptions
Command Descriptions
09-27-02
3-1
Command Descriptions
3.1 Introduction
This section contains detailed descriptions of each of the low and high-level
commands available for the Micro488/p. There are two types of commands: bus
commands and system commands. Bus commands communicate with the IEEE 488
bus. System commands configure or request information from the Micro488/p.
Bus Commands:
A
(ABORT I/O)
C
(DEVICE CLEAR)
C;<addr>
(DEVICE CLEAR w/device specified)
EO;n
(EOI ENABLE/DISABLE)
EN
(ENTER)
EN;<addr>
(ENTER w/device specified)
L
(LOCAL)
L;<addr>
(LOCAL w/device specified)
LL
(LOCAL LOCKOUT)
O;cmd$
(OUTPUT)
OA;<addr>;cmd$
(OUTPUT w/device specified )
RE
(REMOTE)
RE;<addr>
(REMOTE w/device specified)
RS
(RESUME)
SP;<addr>;
(SERIAL POLL)
SQ
(SRQ CHECK)
TR
(TRIGGER)
TR;<addr>
(TRIGGER w/device specified)
/A
(LOW-LEVEL COMMAND)
/L;<addr>
(SEND LISTEN ADDRESS w/device specified)
/ML
(LOW-LEVEL COMMAND)
/MT
(LOW-LEVEL COMMAND)
/T;<addr>
(SEND TALK ADDRESS w/device specified)
/UL
(LOW-LEVEL COMMAND)
/UT
(LOW-LEVEL COMMAND)