Measurement Computing ADAC/5500 Series Installation - Manual (Page 5)

Step 1 – Install Software
IMPORTANT: Software must be installed before installing hardware.
1. Remove previous version ADAC drivers, if present. You can do this through Microsoft’s
Add/Remove Programs feature.
2. Place the Data Acquisition CD into the CD-ROM drive. Wait for PC to auto-run the CD. This may
take a few moments, depending on your PC.
If the CD does not auto-run, use the Desktop’s Start/Run/Browse feature to select and run
Setup.exe.
3. After the intro-screen appears, follow the screen prompts.
Upon completing the software installation, continue with step 2, Install Boards in Available PCI Bus-Slots.
1107-0940, rev 2.0 908096 ADAC/5500 Series Installation Guide 5