Directed Audio 2 Way Security and Conveniece System VSS-204TW - Manual (Page 9)

Programming LCD remote
T
O ENTER PROGRAMMING MODE
Press and hold the
button until one long beep is heard. Programming mode to customize the
remote’s response is now entered.
NOTE: If no buttons are pressed within 5-seconds,
programming mode will exit with 2-beeps.
B
EEPS
/V
IBRATION
O
N
/O
FF
Press to select beeps/vibration On/Off. Beeps alone, or vibration alone, or beeps and
vibration, or no beeps or vibration can be selected. Refer to the table below for these settings.
Beep/Vibrate settings Programming response Icon display*
Beeps only (default) 1-beep Siren icon On
Vibrate only 1-vibrate Vibrate icon On
Beep & Vibrate 1-beep and 1-vibrate Vibrate and siren icon On
No Beep and No Vibrate 1 long beep Vibrate and siren icons Off
*NOTE: This is icon display during programming..
I LLUMINATION O N /O FF
Press to select LCD backlight illumination On/Off.
The LCD backlight will illuminate when a remote
button is pressed, or a alarm status page is received.
LCD Backlight settings Programming response
ON 1-beep, backlight ON
OFF 2-beeps, backlight OFF
6
© 2006 Astroflex Electronics - All rights reserved