Meinberg TCR511 - Manual (Page 15)

15
Output mode of the serial ports
Two diffrent modes are configurable for each of the serial ports. Mode 'per second'
causes the port to output a timestring automatically on second changeover. In 'on request'
mode the timestring is output on the next second changeover after a serial char '?' ( ASCII
Code 3Fh ) has been received.
SW1-3 Mode COM0
off on request '?'
on per second
Mode of serial port COM0
SW1-6 Mode COM1
off on request '?'
on per second
Mode of serial port COM1