Metz MECABLITZ 34 AF-3 Pentax - Manual (Page 23)

23
2. Preparing the mecablitz for use
When loading the batteries ensure correct pola-
rity. Incorrectly loaded batteries can destroy the
flashgun! All batteries must be of the same
make and have the same charge level. Exhau-
sted batteries must not be thrown into the
dustbin! Contribute to the protection of the
environment and discard exhausted batteries
at the appropriate disposal points.
2.3 Automatic flashgun switch-off
To avoid accidental battery discharge the flashgun
automatically switches itself off to save power
approximately 8 minutes after
- the flashgun was switched on
- the last flash was fired
- tripping the camera release, or
- switching on the camera light metering system.
The green flash-ready indicator is turned off.
To turn on the mecablitz again switch the main
switch OFF and then ON. The flashgun should
always be turned off if it is not being used.
2.4 Mounting/Removing the flashgun
Mounting:
• Turn off the mecablitz.
• Turn the clamping nut upwards against the
case of the flashgun.
• Slide the mecablitz foot completely into the
camera's accessory shoe.
• Turn the clamping nut downwards against the
camera body, thereby securing the flash unit.
Removing:
• Switch off the flash unit before it is removed.
• Turn the clamping nut upwards against the
case of the flashgun and remove the flash unit
from the camera.
☞
ķ
798 47 0049-A1 34 AF-3 P 27.05.2008 16:43 Uhr Seite 23