Blue flame propane/lp gas heater, Installation, Continued – Desa FGHS30LPB User Manual

Page 8: Installing heater to wall, Installing thermostat sensing bulb

Advertising
background image

8

107341

BLUE FLAME PROPANE/LP GAS HEATER

Figure 8 - Mounting Bracket Clearances

WARNING: Maintain minimum

clearances shown in Figure 7. If
you can, provide greater clear-
ances from floor and joining wall.

Figure 7 - Removing Front Panel Of Heater

Methods For Attaching
Mounting Bracket To Wall

Only use last hole on each end of mounting
bracket to attach bracket to wall. These two
holes are 16 inches apart from their centers.
Attach mounting bracket to wall in one of
two ways:

1.

Attaching to wall stud

2.

Attaching to wall anchor

Attaching To Wall Stud:

This method pro-

vides the strongest hold. Insert mounting
screws through mounting bracket and into
wall studs.

Attaching To Wall Anchor:

This method

allows you to attach mounting bracket to
hollow walls (wall areas between studs) or to
solid walls (concrete or masonry).

Decide which method better suits your needs.
Either method will provide a secure hold for
the mounting bracket.

Removing Front Panel Of Heater

1.

Remove two screws near bottom cor-
ners of front panel.

2.

Lift straight up on grill guard until it stops.
Grill guard will slide up about 1/4".

3.

Pull bottom of front panel forward, then
down.

4.

Remove cardboard packing from grill
and glass.

INSTALLATION

Continued

Marking Screw Locations

1.

Tape mounting bracket to wall where
heater will be located. Make sure
mounting bracket is level.

2.

Mark screw locations on wall (see Fig-
ure 8).

Note:

Only mark last hole on each end

of mounting bracket. Insert mounting
screws through these holes only.

3.

Remove tape and mounting bracket
from wall.

33"

Min.

10

1

/

4

"

Min.

17

3

/

8

"

Adjoining Wall

Only Insert Mounting

Screws Through Last

Hole On Each End

Floor

INSTALLING HEATER TO
WALL

Mounting Bracket

The mounting bracket is located on back panel
of heater. It has been taped there for shipping.
Remove mounting bracket from back panel.

Mounting
Bracket

Figure 5 - Mounting Bracket

INSTALLING THERMOSTAT
SENSING BULB

Remove clip and bulb from shipping loca-
tion. Place clip and bulb into operation loca-
tion (see Figure 6)

Figure 6 - Moving Thermostat Sensing
Bulb

Advertising