Microsens Gigabit Ethernet Micro Switch 6 Port PoE+ Generation 6 - Manual

Commissioning
Gigabit Ethernet Micro Switch Gen. 6
For devices with integrated 230 VAC power supply the installation must be done only by qualified
professionals. The correct assignment of the L- and N-wires and the earthing has to be respected
(according to the drawing on the type label).
For devices with 44-57 VDC power supply the correct polarity (+/- clamp description) has to be
respected.
Earthing of the device is always required.
Installation and power supply
After connecting the power supply the switch is ready for operation with default values.
Reset of the switch
There are two buttons on the left of the label field of the device (see drawing). By pressing the reset button
(hardware reset) the memory and the MAC table are erased and all connections are reinitialized. The
configuration of the device (switch and management) remains unchanged.
Reset to factory default values
Assigning an IP address
Use of the ‘IP Config Tool’
If the ‘factory defaults’ button is pressed and released after:
- 2s ‘sys’ LED switches to static blue - switch will trigger IPtool
- 10s ‘sys’ LED starts blinking blue - switch will load factory defaults except IP settings
- 20s ‘sys’ LED turns to blinking magenta - switch will load factory defaults including IP settings
If the button is pressed for more than 30 seconds, the lights turns green and no action is performed
sys-LED returns to off state, when button is released!
For the commissioning of the network management the switch must be configured with a valid IP address.
This can be done automatically via DHCP (factory default) or manually by using the ‘Switch IP Config Tool’ or
the ‘NMP Software’.
The ‘Switch IP Config Tool’ is on our web page www.microsens.com available for downloading. After
installation select the network interface which is used by the PC. Use of the IPtool requires that the device is
connected to the same subnet as the PC running the tool.
With the button ‘MAC-based Device Discovery’ all Micro Switches in the same segment are detected and
listed.
User Levels for Management Access
After the successful IP configuration the network management can be accessed via web (http/https) and
Telnet/ssh. The following user levels are available as default:
Management Software NMP
Firmware-Updates
With the Network Management Platform (NMP) MICROSENS offers a universal management software for the
central configuration and administration of all MICROSENS devices. With the clear graphical visualisation and
intelligent mechanisms the administrator is relieved from his work. The latest version can be found on our
web page www.microsens.com for download. For use of the software a license key is required.
For firmware updates, please check www.microsens.com. For further questions please contact our support at
[email protected]
User Passwort Access Description
public microsens read only It is not possible to change any configuration
user microsens limited write Write access to selected parameters, e.g. alias, time-setup,
test-functions etc.
admin administrator full rights All configurations can be made
V1.3-0713-PK
Installation of SD Card
Before starting installation, please insert the supplied SD-Card into the ‘card’-slot on the side (see drawing).
SD-Card Slot
Hardware Reset
Status-LED
Factory Defaults
MICROSENS GmbH & Co. KG, Küferstraße 16, D-59067 Hamm, Germany