MK Products Advanced Color Logic - Manual (Page 23)

Advanced Color Logic Owner’s Manual - Page 16
If at the MAIN SCREEN (weld screen), the text keys will become ACL
program function keys.
When modifying a procedure, and the cursor line is located at the weld
procedure description, all key functions are in text entering mode only.
3.5 Welding Function Control Keys and Clickable Icons
These are the keys that control the welding procedure operations prior to and
during welding or testing.
Use the [S] key or click on [START/STOP] icon to start/stop the procedure.
When pressed, while viewing the Weld Screen, the loaded procedure will
start.
If pressed during the welding or testing of the welding procedure, the
procedure will stop.
Use the [Home] or [F] keys or [FINAL SLOPE] or [HOME] icons to proceed
with final slope or home function.
If pressed during the welding or testing of the welding procedure, all levels
will skip and initiate the Final Slope.
If pressed at any other time while at the Weld Screen, the rotor will move
(jog) to its home position at the high calibration speed value. If the rotor is
already at home position, the rotor will then backup several degrees, then
forward again to home.
If using a Degree procedure, pressing the [Home] or [F] keys will
immediately start the next level and will not finish until it reaches the
programmed position of that level.
Use the [N] key or [NEXT LEVEL] or [GAS] icons to proceed with next level
or gas functions.
If pressed during the welding or testing of the welding procedure, the
procedure will jump from its current procedure level to the next procedure
level.
Subsequent pressing of this key will continue to jump to the next levels of
the procedure until the Final Slope is reached.
If using a Degree procedure, pressing the [N] key will immediately start the
next level and will not finish until it reaches the programmed position of
that level.
Pressing [N] key or gas icon prior to starting the procedure will cause the
Arc Gas and Backup Gas (if connected) to start flowing. The gas will not
turn off until this, or another gas key is pressed again.
If the gas flow is off, the inert shielding gas will automatically turn on
(‘flow’) once the procedure is started by pressing the [S] key.
In order to jog the rotor, either prior to or after running the procedure, use
the combination of [Shift + 6] or [Shift + 7] or Jog Forward/Reverse icons
for forward or reverse rotation, respectively.
To jog the rotor in the normal welding direction (clockwise direction),
press [Shift + 6] or Jog Forward icon. To jog the rotor in the opposite
(counter-clockwise) direction, press [Shift + 7] or Jog Reverse icon.
Either key will jog the rotor in their respective directions, at a speed of 5
rpm.
3.6 Scaling Keys
During the welding and testing mode, the operator may scale both the current
and rotor speed values as the procedure allows. This can be accomplished
using the cursor keys.
See pg 43, #4
See pg 43, #1
See pg 43, #5
See pg 43, “A”
See pg 43, #2
See pg 43, “B”
See pg 43, “C”