MK Products CobraMig 260 PS/Feeder - Manual (Page 10)

CobraMig 260 Owner's Manual - Page 4
Wire Conduit Inlet
Front panel access to attach conduit to front of slave motor assembly.
Power Cable Inlet
Front panel access to attach power cable (air or water) to top of power block.
Gas Inlet
Front panel access to attach gas hose to bottom fi tting of power block.
Water Inlet (For Water Cooled Torches)
Front panel access to connect the water hose to the middle fi tting on the
power block.
Shielding Gas Connection
Remove the screws from the left hinged door, as viewed from the front, and
open door.
Route the gas hose from the regulator/fl owmeter through the grommet on the
back panel and into the 5/8-18 R.H. fi tting on the power block.
DANGER
Welding gases can cause serious injury or death.
Read manufacturer’s instructions before installing, using,
or servicing the regulator, gas hose, or gas cylinder.
Do not touch cylinder with electrode. Keep cylinder away from all electrical
circuits. Keep gas cylinder secured so that it cannot move.