More features, Certification – Monster iSport SuperSlim Wireless Bluetooth In Ear Sport Headphones User Manual
Page 9
More Features
Battery Indicator
When the headphone is connected to a device with
iOS system, a battery indicator will appear at the
upper right of the system, indicating battery status
of the headphone.
Auto Power-Off
When the distance between the headphone and
the mobile phone is beyond effective range, a
warning tone will be alerted and headphone will try
to reconnect with the mobile phone for 10 minutes.
If no phone is reconnected within 10 minutes, the
headphone will go to connectable mode and wait
for 5 more minutes before automatically power off.
Automatic Connection After
Powering On
When the headphone and phone have been
paired once, they will automatically connect when
the headphone is on and Bluetooth is activated
on the phone.
Connection Standby
After successful pairing and connection, you will
hear the voice prompt “Phone 1 connected”. The
headphone will be in turning on mode or standby
mode automatically and the blue LED will flash
once every 5 seconds. When the phone disconnects
the headphone, you will hear the disconnect tone.
Reset Paired Device(s)
Go to the Pairing mode (hold the Multifunction
button for 5 seconds from Power off state), then
hold the Volume “-” to reset the paired device(s),
indicator light flashes blue and red alternatively
and rapidly few times, you will also hear the tone.
Hardware Reset
Plug the Micro USB cable into the USB micro port
of headphone to connect it to the computer or
other device made for USB charging to have the
hardware reset.
Certification
FCC ID: RJE190653
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any
interference received, including interference
that may cause undesired operation. Changes or
modification not expressly approved by the party
responsible for Compliance could void the user’s
authority to operate the equipment. Connecting of
peripherals requires the use of grounded shielded
ENGLISH