Nevion 3GHD-EO - Manual (Page 18)

3GHD-EO / 3GHD-EO-2 Rev. E
nevion.com | 18
6 RS422 commands
This card uses the FLP 4.0 protocol to be configured and monitored. See separate
documents for definition of this protocol.
6.1 FLP4.0 block commands
Common FLP4.0 block for both single and dual converter is listed below.
6.1.1 CEQ 0
Electrical input 1.
<identifier> ::= 'ceq'
<status> ::= ['cd'|'ncd'] ['bypass'|'mute']
<block command> ::= 'enable'|'bypass'|'mute'
6.1.2 CEQ 1
Electrical input 2.
<identifier> ::= 'ceq'
<status> ::= ['cd'|'ncd'] ['bypass'|'mute']
<block command> ::= 'enable'|'bypass'|'mute'
6.1.3 TEMP 0
Board temperature.
<identifier> ::= 'temp'
<status> ::= ['alarm'] [<temperature>'C'] ['ulim' <temperature>]
['llim' <temperature>]
<block command> ::= <upper limit>|<lower limit>
<upper limit> ::= 'ulim' <temperature>
<lower limit> ::= 'llim' <temperature>
6.1.4 PWR 0
<identifier> ::= 'pwr'
<status> ::= [<nominal voltage>'Vnom'] [<voltage>]
6.1.5 PWR 1
<identifier> ::= 'pwr'
<status> ::= [<nominal voltage>'Vnom'] [<voltage>]
6.1.6 LSR 0
Optical output 1.
<identifier> ::= 'lsr'
<status> ::= ['T'|'C'|'D'] [<wavelength>'nm'] [<power>'dBm']
['on'|'off'] ['fail']
<block command> ::= <operation>|<type>|<wavelength>|<power>
<operation> ::= 'on'|'off'
<type> ::= 'type' 'T'|'C'
<wavelength> ::= 'lambda' <laser wavelength>
<power> ::= 'lpwr' <laser power>