Nevion LB-EO Rev.F - Manual (Page 8)

LB-EO Rev. F
nevion.com | 8
DIP switch configuration must be set according to the table below:
Switch
#
Label
Function,
DIP = ON
Function,
DIP = OFF
Comment
1 AGC Automatic gain
control Manual gain control
2 R/S Run AGC Sample AGC level Only valid in Manual gain
control
3 LNB Enable power
supply for LNB Disable power
supply for LNB
4 H/V Horizontal
polarization Vertical polarization Sets voltage on LNB
5 LLC Line length
compensation on Line length
compensation off If on, output voltage from card
to LNB will increase by 1 volt.
Set to ON when using long
cables (cable more than
approx 3 ohms DC resistance
in cable)
6 H/L High band Low band 22kHz tone control
7 GPI H/V and H/L
controlled by GPI H/V and H/L
controlled by DIP
or GYDA When GPI is set, DIP 4 and 6
will be disregarded
8 OVR Override GYDA
control. Config.
with DIP switch GYDA control.
Config. with GYDA Select configuration from
GYDA
All DIP switches are off when pointing towards the release handle.