NewHank Workmate - Manual (Page 6)

41. CH3 MIC 1 -- Connect a microphone to this 6.3mm input.
42. CH4 AUX3 -- Do not connect turntable’s to these jacks. CD players, Tape decks or other line level
sources can be connected. The red colored RCA jack represents the right channel input and the
white jack the left channel input.
43. CH4 LINE4 --Do not connect turntable’s to these jacks. CD players, Tape decks or other line level
sources can be connected. The red colored RCA jack represents the right channel input and the
white jack the left channel input.
44. CH4 MIC 2 -- Connect a microphone to this 6.3mm input.
45. REC- - Use this RCA fixed output signal for recording etc
46. MASTER -- Unbalanced RCA stereo output for short cable runs.
47. BALANCED XLR --Balanced stereo output for short and long cable runs.
48. BOOTH --Use this output signal to drive a booth monitor or separate sound
system. The output level for these 6 . 3 m m jacks is controlled by the BOOTH volume knob(16).
49. IEC POWER SOCKET -- Connects to mains with the supplied power-cord.
SPECIFICATIONS
Installation: Place on flat surface or mount in 19" rack.
Power supply: Integrated transformer AC 230V-50Hz.
Power consumption: 12W typical, 21W w/ full headphone output.
Operating Temperature: 5 to 35 deg. CC; Humidity: 25 to 85%.
(Non-condensing); Storage Temperature: -20 to 60 deg. C
Dimensions: 19" 2he Rack mount, Front 483x88mm Rear:438x85mm.
Please Note: All specifications and improvements to and in the design of this unit and its manuals are
subject to change at any time without any prior written or published notice.
page 6
NEWHANK www.newhank.com Workmate Instruction Manual