NewHank Inmate - Manual (Page 3)

QUALITY AV PRODUCTS
1
23
21
16
24 24
14 17 15
2
3
4
5
6
10
9
8
7
11
12
13
10
9
8
7
11
12
13
10
9
8
7
11
12
13
10
9
8
7
11
12
13
10
9
8
7
11
12
13
18 19 19
20
22 25
NEWHANK - www.newhank.com - INMATE/USB Instruction Manual Page 3
FACE PANEL FUNCTIONS
1. POWER LED --
2. MIC ON/OFF --
3. MIC GAIN --
4. MIC BASS --
5. MIC TREBLE --
6. MIC INPUT --
7. CHANNEL GAIN --
8. CHANNEL TREBLE --
9. CHANNEL MID --
10. CHANNEL BASS --
11. INPUT SELECTOR --
12. PFL --
13. CHANNEL FADER --
14. CUE GAIN --
15. CUE BLEND --
16. BLEND / SPLIT --
17. HEADPHONES --
18. CROSSFADER --
19. CROSSFADER ASSIGN --
20. MASTER FADER --
21. STEREO / MONO --
22. BALANCE --
23. MASTER/PFL --
24. LED VU Meters --
25. ZONE --
This control can be used to adjust the audio feed to an extra amplifier, powered monitors or lighting console etc.
Illuminates in red when the mixer is powered on.
Turns the dedicated microphone input on or off.
Adjusts the audio level of the microphone signal.
Adjusts the low (bass) frequencies of the microphone channel.
Adjusts the high (treble) frequencies of the microphone channel.
Connect a microphone to this COMBO input that accepts either an XLR or a 1/4 ” jack connector.
Adjusts the corresponding channel pre-fader and pre-EQ gain level.
Adjusts the high (treble) frequencies of the audio on the corresponding channel.
Adjusts the mid-range frequencies of the audio on the corresponding channel.
Adjusts the low (bass) frequencies of the audio on the corresponding channel.
Selects the input source to be routed to the corresponding channel. Input jacks are located on the
rear panel.
Sends pre-fader, post -EQ audio of the corresponding channel to the headphone monitoring section and also the
VU meters when (23) is pressed.
Adjusts the audio level on the corresponding channel.
Adjusts the audio level of the headphones.
Slide this to mix the Cue channel and Program mix in the headphones. When all the way to the left, only
channels routed to the Cue channel will be heard. When all the way right, only the Program mix will be heard.
When pressed, this button sends all audio in the Cue channel to the left side of the headphones and
the Program mix to the right side of the headphones. When raised, you may control the balance of the Cue channel and
Program mix with the CUE BLEND fader.
Connect your headphones to this output for cueing and mix monitoring.
Blends audio between the channels assigned to the left and right side of the crossfader. This part is us-
er replaceable, Part-number CF-1.
nables you to route 1 of 4 channels via the crossfader. Now you can use 1 fader to simply
mix 2 channels.
adjusts the main master output volume.
When pressed your main master output will be MONO.
Adjusts your left to right balance on both the RCA and XLR Master outputs.
When pressed you see the pre fader cue signal(s) on the VU Meters. When raised you see the post fa-
der Master program signal on the VU Meters.
can indicate either the master output or cue channel input levels, depending on the position of the
MASTER/PFL switch (23).
Is a second and adjustable stereo Master program output.
E