Rear panel connections, Usb operation – NewHank Inmate User Manual
Page 4
NEWHANK
- www.newhank.com - INMATE/USB Instruction Manual Page 4
QUALITY AV PRODUCTS
1
2
2
1
2
2
1
2
2
2
2
3
3
4
5
6
7
8
10
8
9
9
11
1.
Turn on your computer and the INMATEUSB.
2.
Use a USB cable to connect one or both ports of the INMATEUSB to your computer.
3.
Windows will immediately recognize the mixer as a "USB Audio Device
”or "USB Audio CODEC”and will
automatically install any required system components.
1
2
2
1
2
2
1
2
2
2
2
2
2
3
3
4
5
6
7
8
9
REAR PANEL CONNECTIONS
1.
AUX INPUTS (RCA) --
2.
LINE INPUTS (RCA)--
3.
MIC INPUTS --
4.
ZONE OUTPUT (RCA) --
5.
RECORD OUTPUT (RCA) --
6.
MASTER OUTPUT (RCA) --
7.
MASTER OUTPUT (BALANCED) --
8. * USB --
9. * USB SELECT --
8(10).
POWER IN --
9(11).
POWER SWITCH --
CD, DVD- players, Tape Decks and other line level devices may be connected to these ja-
cks. The red colored RCA jack represents the right channel input and the white represents the left channel input.
CD, DVD players, Tape Decks and other line level devices may be connected to these inputs.
Connect microphones to these inputs.
Connect this output to an extra amplifier, powered monitors or a lighting console.
Use standard RCA cables to connect this output to a recording device. The level of t-
his output is based upon pre-master levels.
Use standard RCA cables to connect this output to a speaker or amplifier system. The
level of this output is controlled by the MASTER fader on the face panel.
Use XLR cables to connect this output to a speaker or amplifier system.The l-
evel of this output is controlled by the Master fader on the face panel.
These USB connections send and receive audio from a connected computer. The functionality of each port
(send or receive) depends on the position of the corresponding USB SELECT switch.
These switches determine the functionality of the USB ports.
USB A switch set to MASTER sends the program Mix output to your computer.
USB A switch set to CH3, sends audio from your computer to CH3 input.
USB B switch set to REC send the record output to your computer.
USB B switch set to CH4, send audio from your computer to CH4 input.
Use the included power cable to connect the mixer to a power outlet.
Turns the mixer on and off.
USB OPERATION*
The
is equipped with two USB ports that allow you to play content from your computer through the mixer,
or record audio from the mixer directly into your favorite software application. The USB interface on your mixer works with
your computer just like a standard USB
“plug and play” sound card.
INMATE USB
WINDOWS CONFIGURATION*