Denon DVD-2500BTCi - Manual (Page 10)

7
Introduction Introduction
ENGLISH
ENGLISH
The unit can also be turned on by pressing the buttons with circled numbers.
Part Names and Functions
Front Panel
DVD-2500BTCI BLU-RAY DISC PLAYER
HDMI RESOLUTION SD CARD
ON / STANDBY
3
5 6 9 10 11
13 2 1
12
4 7 8
1. ON/STANDBY button
Press to turn the unit on or off.
2. Power indicator
This indicator lights up in green when the
power is on, and lights up in red when in
standby mode.
3. Infrared sensor window
Receive signals from your remote control so
that you can control the unit from a distance.
4. Disc tray
Place a disc when opening the disc tray.
5. Display
Refer to “Front Panel Display” on page 9.
6. SD CARD slot
Insert an SD Memory Card, and play back the
contents in it.
7. A (OPEN/CLOSE) button
Press to open or close the disc tray.
8. B (PLAY) button
Press to start or resume playback.
9. C (STOP) button
Press to stop playback.
10. H / G (SKIP DOWN/UP) button
Press to skip down/up titles/chapters/tracks/
file.
11. h / g (FAST FORWARD/REVERSE)
button
During playback, press to fast forward / fast
reverse the playback. When playback is in
pause, press to slow forward the playback.
12. F (STILL/PAUSE) button
Press to pause playback.
13. HDMI RESOLUTION button
Press to set the HDMI jack’s video signal
output mode.
Rear Panel
Note
• Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause
permanent damage to the unit.
AC IN
RS-232C
STRAIGHT CABLE
IN OUT ROOM TO ROOM
REMOTE CONTROL
HDMI OUT
2
4 3
1
1. HDMI OUT jack
Use an HDMI cable to connect to a display
with an HDMI jack.
2. CONTROL CONNECTOR (RS-232C)
Control terminal for system extension.
3. ROOM TO ROOM IN / OUT jacks
Connecting the DENON Satellite Remote
Control to these jacks enables you to
operate more than one DENON components
with one remote control.
4. AC IN Terminal
Use the AC cord to connect to the AC outlet.
E5E01UD_EN.book Page 7 Wednesday, November 28, 2007 2:16 PM