Denon DVD-2500BTCi - Manual (Page 25)

22
Playback Playback
ENGLISH
ENGLISH
You can enjoy stereo phonic virtual space through your existing
2-channel stereo system.
1) In stop mode, press [MODE] repeatedly until the virtual
surround setting appears.
2) Use [U / V] to select “1” (Natural effect), “2” (Emphasized
effect) or “Off”.
3) Press [RETURN] to exit.
By selecting the pure direct mode, you can shut down the circuitry
of the front panel.
1) Press [PURE DIRECT] repeatedly to select your desired pure
direct mode.
• Each time you press [PURE DIRECT], the pure direct mode
changes as “Normal” A “Display Off” A “Normal”. The
modes will be displayed on the front panel display.
BD audio mode is to choose between two ways; you could output
the secondary and interactive audio accompanied by the primary
audio or you could output the primary audio only. Depending on
the setting of the mode, Dolby Digital, DTS, Dolby Digital Plus,
Dolby TrueHD, or DTS-HD output changes between multi LPCM
and bitstream.
1) In stop mode with BD inserted, press [MODE].
2) Use [U / V] to select desired setting.
BD Audio Mode
• The secondary audio is the audio for the sub picture
(Director's comment etc.) and the interactive audio is the
audio for the interactive application (Button click sounds
etc.).
3) Press [RETURN] to exit.
• You can also set the BD Audio Mode from the setup menu.
Refer to page 30.
Item Description
Adjustment range
(*:default)
Noise
Reduction Reduces the noise of the
playback picture.
Off*
+1: Execute MPEG
noise reduction
witch reduce the
block noise and
mosquito noise on
the subtitle on
movie.
+2: Execute 3D noise
reduction witch
detect and delete
the noise by
comparing each
picture frames.
+3: Execute both
MPEG noise
reduction and 3D
noise reduction.
Note
• The setting remains even you turn off the unit.
• You cannot adjust the setting during the dialog speed
playback.
• For BD, noise reduction is not effective.
Virtual Surround
Note
• Select virtual surround “Off” or lower the volume if the
sound is distorted.
• This function cannot be used during dialog speed (refer to
page 15).
• For the virtual surround, audio signal will always be
2-channel LPCM.
Pure Direct Mode
“Normal” : Pure direct mode is off.
[PURE DIRECT]
“Display Off” : Front panel display will be turned off.
Note
• The “Display Off” mode goes back to “Normal” mode if you
turn off this unit.
DVD-V DVD-VR BD-V
Off
Setting the BD Audio Mode
“Mix Audio Output” : The Dolby Digital, DTS, Dolby
Digital Plus, Dolby TrueHD or
DTS-HD format will be converted to
Multi LPCM. If it is available,
secondary and interactive audio it
will be output with primary audio.
“HD Audio Output” : Dolby Digital, DTS, Dolby Digital
Plus, Dolby TrueHD, or DTS-HD will
be output in a full stream. Please
refer to page 11 for output audio
signals. In this mode secondary or
interactive audio will not be output.
BD-V
E5E01UD_EN.book Page 22 Wednesday, November 28, 2007 2:16 PM