Temperature inputs, Shield – ONICON System-10 P1 User Manual
Page 18
Advertising

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • [email protected]
System-10-P1 Manual 10/14 - 0656-9 / 18320
Page 18
3.3.2 Input Signal Connections
Make connections on the mother board, located in the main unit, at terminal strips
T3, T4 and T5. Do not exceed 4.5 in-lb (0.5 Nm) of torque when tightening.
3.3.2.1 Input Signal Connections from Temperature Sensors
* Reference (Black)
* Reference (Black)
* Signal (Red)
* Signal (Red)
* Shield
Temperature Inputs
Supply temperature
Sensor
Return temperature
Sensor
L1 N
Not Used
!
CAUTION
Shield connections are required for proper operation. Failure to use shielded cable may result in
erratic operation.
Advertising