OpenEye OE4 N-Series - Manual (Page 24)

24
INSTALLING THE N1 INTO A TELCO RACK
To install the Openeye 1U NVR into a Telco type rack, use two L-shaped brackets on either side of the chassis (four total). First,
determine how far forward the server will extend out the front of the rack. Larger chassis should be positioned to balance the weight
between front and back. If a bezel is included on your NVR, remove it. Then attach the two front brackets to each side of the chassis,
then the two rear brackets positioned with just enough space to accommodate the width of the Telco rack. Finish by sliding the chassis
into the rack and tightening the brackets to the rack.
Figure 1-4. Installing the N1 into a Telco Rack