Dome setup and cable connection, Preparations for dome setup – OpenEye CM-512 Installation Manual User Manual
Page 13
Advertising
31515AB
13
DOME SETUP AND CABLE CONNECTION
Before installing or connecting the dome camera, please refer to this section and
complete preparations for dome setup and all switch settings.
Preparations for Dome Setup
The following installation procedure is for the outdoor dome equipped with the sunshield housing.
Please follow the steps below to complete dome housing installation.
1. Unpack the dome package and take out the dome body.
2. Remove the protective cover and PE sheet.
3. Attach the dome cover to the camera body. Before doing that, apply some
lubricant to the waterproof gasket. This helps keep moisture out of the dome.
Note
The protrusion on the cover must alight with one of the four holes on the camera body.
Advertising