Orien FSW-120 - Manual (Page 4)

Installation
Remove the exterior and interior packaging. Use a soft dry
cloth to wipe down the outside of the wine cellar thoroughly.
Use a clean cloth dampened with lukewarm water to wipe
down the inside of the cellar.
Air must circulate freely in front of the wine cellar. Avoid
placing the cellar near any source of heat or moisture, or in
direct sunlight. Direct sunlight may affect the finish, and
nearby heat sources will cause higher electrical consumption.
The FSW-120 wine cellar is designed to be built-in. A
motorized fan at the back of the unit directs
compressor-generated heat away from the compressor and
through the front of the unit. There
are no clearance
requirements for this unit.
Once the wine cellar is positioned, the leveling legs at the front
of the unit should be turned to level the appliance. This will
reduce vibrations.
Electrical Connection
Important! For your personal safety, this appliance must
be properly grounded. In the event of an electrical short
circuit, grounding reduces the risk of shock by providing an
escape wire for the electric current.
This appliance is
equipped with a cord having a grounding wire with a grounding
plug. The plug must be inserted into an outlet that is properly
grounded and installed. Consult a qualified electrician if you
do not completely understand these grounding instructions.
DO NOT UNDER ANY CIRCUMSTANCES CUT OR
REMOVE THE THIRD (GROUND) PRONG FROM THE
POWER CORD.
3