Fireplace installation – Desa (V)K36N User Manual

Page 20

Advertising
background image

www.desatech.com

111923-01D

20

FIREPLACE INSTALLATION

Continued

3. If installing brick liner in new fireplace, go to step 4. If install-

ing brick liner in an existing fireplace, carefully remove logs,

lava rock, and ember material.

4. Remove three screws from deflector shield on the inside top

of firebox. Set shield and screws aside.

5. Install rear brick panel first. Rest bottom edge of panel on back

edge of grate (see Figure 42).

6. Install left side brick panel by sliding it between burner as-

sembly and side of fireplace (see Figure 42).

7. Install the right brick panel using the same method described

in step 6 for the left brick panel.

8. Replace deflector shield using screws removed in step 4.

9. Install logs, lava rock, and glowing embers (see Installing Logs,

Lava Rock and Glowing Embers).

10. Close glass door, lock latches on top and bottom of door and

replace screen (see steps 5 and 6 of Removing/Replacing Glass

Door, page 19).

11. Close top and bottom louvers.

INStALLING LOGS, LAvA ROCK AND
GLOWING EMbERS

Each log is marked with a number. These numbers will help you

identify the log when installing. It is very important to install these

logs exactly as instructed. Do not modify logs. Only use logs sup-

plied with fireplace.

Open louvers, remove screen, unlock door latches, and open glass

door. See Removing/Replacing Glass Door, steps 1 and 2 on page 19.

Install logs according to instructions for fireplace model numbers.
1. Place log #1 (left base log) onto pin on left side of burner as

shown in Figure 43.

2. Place log #2 (right base log) onto pin on right side of burner

as shown in Figure 43.

3. Place logs #3 (left front log) and log #4 (right front log) onto

pins as shown in Figure 44.

4. Place log #5 (right rear log) onto pins on right rear of burner

(see Figure 45). Rest log #6 (middle crossover log) on top of

log number 2 as shown in Figure 45.

5. Place back end of log #7 (left rear log) onto pin on left rear burner

and rest front onto log #1 as shown in Figure 46, page 21.

1

2

Figure 43 - Installing Logs No. 1 and No. 2

3

4

5

6

Figure 44 - Installing Logs No. 3 and No. 4

Figure 45 - Installing Logs No. 5 and No. 6

Figure 42 - Installing Rear Brick Panel

Left Side

Brick Panel

Rear

Brick

Panel

Advertising