Paslode CF325Li Li-ion Cordless Framing - Manual (Page 19)

19
Tool operates properly, but fasteners do not
drive fully.
Tool operates, but no fastener is driven.
Tool operates erratically or appears to be
losing power - tool indicator light is green.
Work-contacting element requires adjustment.
Dirty air filter.
There may be loss of seal in combustion
chamber.
Wrong fasteners being used.
Tool requires cleaning.
Follower not properly engaged behind fastener
strip.
Jammed fastener.
Spark plug wire is loose.
Filter element is dirty, causing tool to overheat.
Adjust work contacting element.
Clean filter.
Press work contacting element against
workpiece for 20 seconds. Pull trigger. If
fastener does not drive, there is a leak that
requires service.
Use only fasteners meeting Paslode ®
specifications. Check Fasteners and
Applications section for fastener types and
sizes recommended for use in Cordless tool.
Clean per instructions.
Position follower behind fastener strip and
engage strip.
Clear jam.
Check spark plug wire.
Remove filter element and clean. Use soap
and water to remove stubborn debris.
Normal Stage of Operation
E C I V R E S S M E L B O R P E L B I S S O P M O T P M Y S
Tool operated and drove fasteners, but
driver blade did not return to up position.
Combustion chamber does not drop after
tool cycles.
Built-up dirt and debris on driver blade or in
nose bore.
Mid check is dirty or disabled.
Work-contacting element is bent or is dirty.
Clean driver blade and nose bore with
degreaser cleaner.
Return tool to authorized Paslode ® Cordless
dealer for service.
Clean or replace work-contacting element.
Troubleshooting
If tool will not operate after following the above service directions, return the tool to an
authorized Paslode.® representative for service.
For the nearest Paslode® representative call 1-800-682-3428.
For Technical support call 1-800-222-6990 or visit our web site at www.paslode.com.
To purchase parts, visit our website at www.itwconstructionparts.com