Progressive Turf Equipment Pro-Max 36 - Manual (Page 38)

38
TROUBLESHOOTING:
PROBLEM CAUSE REMEDY
VIBRATION WHEN
TURNING DRAWBAR LENGTH
INCORRECT CHECK DRAW BAR
LENGTH SPECS AND
ADJUST HITCH PLATE
VIBRATION WHEN
TURNING MAIN INPUT SHAFT NOT
COLLAPSING EASILY PULL INPUT SHAFT
APART AND GREASE
INNER AND OUTER
SPLINES. NOTE THERE
ARE TWO GREASE ZERKS
AT MIDSHAFT. GREASE
BOTH EVERY 8 HOURS OF
USE.
INTERMEDIATE PTO
SHAFT DAMAGE TO
SPLINED STUB. MAIN INPUT SHAFT IS
NOT COLLAPSING
EASILY DUE TO
INSUFFICIENT GREASE
ON SPLINES REPEAT AS PER ABOVE.
IN HOT OPERATING
TEMPERATURES GREASE
EVERY 4 HOURS
PREMATURE SPINDLE
BEARING DAMAGE INSUFFICIENT GREASE
ON BEARINGS GREASE EVERY 8 HOURS
OF USE. IN HOT
TEMPERATURES GREASE
EVERY 4 HOURS.
PREMATURE SPINDLE
BEARING DAMAGE.
GREASE IS BLACK, DRY
AND PASTY ON
EXAMINATION CONTAMINATED GREASE SEE INFORMATION ON
GREASE COMPATIBILITY
IN THIS MANUAL
FRONT DECKS CUT
HIGHER/LOWER THAN
REAR DECKS TRACTOR HYDRAULIC
CONTROL NOT IN FLOAT
POSITION WHEN LOWERING
DECKS, BE SURE THE
FRONT SECTION IS IN
FULL FLOAT POSITION
ONE DECK ON FRONT
SECTION GIVING A
RAGGED CUT THE FOUR WAY GEAR
BOX MOUNTED
INCORRECTLY AND THE
BLADES ARE TURNING IN
WRONG DIRECTION WHEN MOUNTING FOUR
WAY GEARBOX THE
BREATHER MUST BE IN
THE REAR RIGHT HAND
SIDE LOOKING AHEAD