Denon AVR-2802/982 - Manual (Page 35)

ENGLIS
35
Clearing “learned” remote control signals
1 Press the USE/LEARN selector button with the tip of a pen,
etc., to set the learn mode.
DVD
START LEARNED/TX
SPEAKER
TUNING
BAND
TITLE MENU/GUIDE
MODE
MEMORY
USE/LEARN T.TONE MULTI DVD
SET UP
RETURN
STATUS
DISPLAY
ON SCREEN
DOLBY / DTS
SURROUND DIRECT
DSP SIMULATION 5CH / 6CH STEREO STEREO
INPUT MODE ANALOG EXT.IN
MUTING
MASTER VOL.
VOLUME DISC SKIP+
SYSTEM CALL POWER
VDP TUNER SHIFT
TV/DBS PHONO
VCR-1 CD CHANNEL
VCR-2/V.AUX TV/VCR
AVR/AVC VIDEO DVD TV
AUDIO
VDP VCR
CD MULTI
CDR/MD TAPE
SYSTEM SETUP SURROUND PARAMETER
CH SELECT
SELECT
RC-903
1 2 3
4
SET
A / B
CALL OFF
ENTER
ON / SOURCE
5 6
7 8 9
+10 0
4
2
1,5
3
CDR / TAPE
4 Press the SYSTEM CALL SET button, and hold it in for at least
four seconds.
• When both the START and LEARNED/TX LEDs light
simultaneously, all the stored codes are cleared.
5 Press the USE/LEARN selector button.
9 OPERATION
Before operating
1 Refer to “CONNECTIONS” (pages 6 to 13) and check that all
connections are correct.
2 Set the remote control unit’s slide
switch to the AUDIO position. (only
when operating with the remote
control unit)
3 Turn on the power.
Press the POWER switch (button).
AVR/AVC VIDEO
AUDIO
ON / STANDBY
(Main unit) (Remote control unit)
When pressed, the power turns on and the display lights. The sound
is muted for several seconds, after which the unit operates normally.
When pressed again, the power turns off, the standby mode is set
and the display turns off.
Whenever the ON/STANDBY button is in the STANDBY state, the
apparatus is still connected on AC line voltage. Please be sure to
unplug the cord when you leave home for, say, a vacation.
3 4
VOLUME LEVEL
AUTO
LOCK
STAND BY DIGITAL PCM
SIGNAL
DIGITAL
INPUT
REMOTE
SENSOR
B
ON / SOURCE
ON/STANDBY
Light
SPEAKER
TUNING
BAND TITLE MENU/GUIDE
MODE
MEMORY
USE/LEARN T.TONE MULTI SET UP
RETURN
STATUS
DISPLAY
ON SCREEN
DOLBY / DTS SURROUND DIRECT
DSP SIMULATION 5CH / 6CH STEREO STEREO
INPUT MODE ANALOG EXT.IN
MUTING
MASTER VOL.
VOLUME DISC SKIP+
TV/DBS PHONO
VCR-1 CD CHANNEL
VCR-2/V.AUX TV/VCR
AVR/AVC VIDEO DVD TV
AUDIO
VDP VCR
CD MULTI
CDR/MD TAPE
SYSTEM SETUP SURROUND PARAMETER
CH SELECT
SELECT
4
A / B
ENTER
5 6
7 8 9
+10 0
2
4
CDR / TAPE
SET
Light
4 Select the front speakers.
Press SPEAKER A or B turn the speaker on.
SPEAKER
2 To clear “learned” remote control signals, set the slide switch
to the position at which the signals were “learned”.
AVR/AVC VIDEO
AUDIO
3 Set the slide switch to the position at which the signals were
“learned”.
DVD TV
VDP VCR
CD MULTI
CDR/MD TAPE