Englis – Denon AVR-2802/982 User Manual

Page 37

Advertising
background image

ENGLIS

37

SIGNAL

DIGITAL

DIGITAL

DIGITAL

SIGNAL

SIGNAL

ANALOG

DIGITAL

DIGITAL

DIGITAL

ANALOG

AUTO

INPUT

PCM

DTS

AUTO

INPUT

PCM

DTS

AUTO

INPUT

PCM

DTS

AUTO

INPUT

PCM

DTS

3

Select the play mode.
Press the SURROUND MODE button, then turn the SELECT
knob.
Example: Stereo

SURROUND

MODE

STEREO

(Main unit)

(Remote control unit)

4

Start playback on the selected component.
• For operating instructions, refer to the component’s

manual.

5

Adjust the volume.

MASTER VOLUME

MASTER VOL.

The volume level is
displayed on the master
volume level display.

(Main unit)

(Remote control unit)

The volume can be adjusted within the range of –70 to 0 to 18 dB,
in steps of 1 dB. However, when the channel level is set as
described on page 22 or pages 42 and 43, if the volume for any
channel is set at +1 dB or greater, the volume cannot be adjusted
up to 18 dB. (In this case the maximum volume adjustment range
is “18 dB — (Maximum value of channel level)”.)

Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the

“ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to “DTS”.

Input mode display

• In the AUTO mode

• In the DIGITAL PCM mode

• In the DIGITAL DTS mode

• In the ANALOG mode

One of these lights, depending on the
input signal.

Input signal display

• DOLBY DIGITAL

• DTS

• PCM

SELECT

To select the surround mode while adjusting the surround
parameters, channel volume or tone control, press the surround
mode button then operate the selector.

SURROUND

MODE

(Main unit)

The

indicator lights when digital signals are being input

properly. If the

indicator does not light, check whether

the digital input component setup (page 24) and connections are

correct and whether the component’s power is turned on.

DIGITAL

DIGITAL

NOTE:
• The

indicator will light when playing CD-ROMs

containing data other than audio signals, but no sound will be
heard.

DIGITAL

Advertising