Dukane Projector 8794H-RJ - Manual (Page 23)

23
Operating
Selecting an aspect ratio
● ASPECT button does not work when no proper signal is inputted.
● NORMAL mode keeps the original aspect ratio setting.
1. Press SEARCH button on the remote control.
The projector will start to check its input ports as below in
order to fi nd any input signals.
When an input is found, the projector will stop searching
and display the image. If no signal is found, the projector will
return to the state selected before the operation.
Searching an input signal
● While ON is selected for AUTO SEARCH item in OPTION menu (53), the
projector will keep checking the ports in above order repeatedly till an input
signal is detected.
● It may take several seconds to project the images from the USB TYPE B port.
 For a computer signal
NORMAL  4:3  16:9  16:10
 For a video signal, s-video signal or component video signal
4:3  16:9  14:9

For an input signal from the LAN, USB TYPE A or USB TYPE B port, or
if there is no signal
4:3 (fi xed)
1. Press ASPECT button on the remote control.
Each time you press the button, the projector switches the
mode for aspect ratio in turn.
ASPECT button
SEARCH button
VIDEO
DOC.CAMERA
KEYSTONE
ASPECT SEARCH BLANK
MUTE MY BUTTON
POSITION
ESC
MENU
RESET
COMPUTER MY SOURCE/
AUTO
MAGNIFY PAGE
DOWN
ON
OFF
FREEZE
UP
ー
＋
VOLUME
1 2
ENTER
 For an HDMI TM signal
NORMAL  4:3  16:9  16:10  14:9
VIDEO
DOC.CAMERA
KEYSTONE
ASPECT SEARCH BLANK
MUTE MY BUTTON
POSITION
ESC
MENU
RESET
COMPUTER MY SOURCE/
AUTO
MAGNIFY PAGE
DOWN
ON
OFF
FREEZE
UP
ー
＋
VOLUME
1 2
ENTER
COMPUTER IN1  COMPUTER IN2  LAN
VIDEO USB TYPE A
S-VIDEO USB TYPE B
HDMI