REMKO RKL 460 - Manual (Page 10)

10
5. Unscrew the fastening clamp of the connecting line.
See Fig. 13.
6. Press on the lug on the side of the connector and
remove the connector from the socket.
7. Remove the upper part of the holder by unscrewing
the two screws.
8. Pull the water tube out.
9. Unscrew the left cap nut with the wrench supplied
SW 24.
Make sure to apply counter-pressure on the lower
coupling with the second wrench SW 21 (Fig 14).
Never turn the inflexible lower part!
10. Keep turning until the connection is detached.
Should refrigerant leak out with a slight hissing
noise, keep turning the screws.
8. Clean the dust filter and the plastic surfaces.
9. Hang the outdoor unit onto the indoor unit.
10. Protect the unit from dust with a plastic tarp.
11. Store the unit in a cool, dry place that is protected
from sunlight.
Fig. 12
Screws
Cover
Fig. 13
Connecting line
Fastening clamp
Connector
Water tube
Holder
11. Unscrew the right cap nut with the wrench supplied
SW 24.
Make sure to apply counter-pressure on the upper
coupling with the second wrench SW 21 (Fig. 15).
Never turn the inflexible upper part!
12. Keep turning until the connection is detached.
Should refrigerant leak out with a slight hissing
noise, keep turning the screw.
During the entire process, the unit must be unplugged
from the power source! It may only be put back into op-
eration wants all connections have been re-established
and tested. The fasteners and all covers must be reat-
tached prior to operation.
You must proceed as follows:
1. Switch the unit off.
2. Unplug the unit from the power supply.
3. Remove the 2 screws on the cover on the back of
the unit (Fig. 12).
4. Remove the cover from the unit.
Detaching the
Connecting Line
The connection line is connecting to the indoor unit by
quick-release fasteners. These make it possible to de-
tach the connecting line from the indoor unit for assem-
bly purposes without any coolant draining out.
Fig. 14
loosen
tighten
*
It is possible that any remaining water will come
out of the water tube.
*
To safely detach the connecting line, make sure to
observe the following instructions.
Apply counter-
pressure
loosen
tighten
Fig. 15
Apply counter-
pressure