REMKO EFS 25-35 - Manual (Page 26)

NOTICE!
Danger of damage and malfunction.
– Only connect components that do not over-
load the inputs and outputs of the con-
troller; for more information, see the name
plate and .
NOTICE!
– The polarity of signal inputs/outputs 1-4
and R
S
is not fixed during connection.
– Only temperature probes of the type
Pt1000 are permitted.
– Probe cables must be located at least 100
mm away from power supply cables.
– Use shielded probe cables if inductive
sources are present, e.g. high-voltage
cables, radio transmitters, microwave units.
REMKO fresh water station Controller
26