Rena EasyFeed 120 - Manual (Page 23)

EasyFeed_120_Operations_
4-25-14
23
Lateral back wedge adjustment plate
The lateral back wedge adjustment plate, part #WC-L650 allows for lateral adjustment of the
back wedge assembly so that it can be used in any position across the width of the feeder
The plate can be easily added to an existing feeder with the back
wedge locking knob already on the feeder.
To install the new back wedge plate, loosen the back wedge plate locking knob on the
feeder to slide the back wedge assembly off.
Using one hand to keep the bolt from falling into the feeder, remove the locking knob and
flat washer from the bolt. Position the new plate’s slot over the bolt and replace the flat
washer and knob onto the bolt as shown below.
The flat washer and locking knob included with the new back wedge lateral adjustment
plate can be used to attach the back wedge assembly.
WHEN USING THE BACK WEDGE AWAY FROM THE CENTER OF THE FEEDER, BE
SURE TO TIGHTEN BOTH LOCKING KNOBS SECURELY TO KEEP BACK WEDGE
ASSEMBLY IN POSITION!
Use existing knob and flat washer
to attach new plate.
Then use included knob and flat
washer to attach back wedge
assembly to new plate.