DTS RV4700 DTS-ES - Manual (Page 32)

32
Select the desired video input source to
enter its label.
1
Press the VIDEO LABEL button to enter
the video label mode.
Example) When selecting VIDEO 1.
2
Select the character on the flickering digit.
3
Confirm your selection.
4
Repeat the above steps and to enter
the desired characters on the rest of the
digits. 5
Memorize the desired video label.
6
Entering a video label
Select the desired video input source to be
rectified or cleared.
1
Repeat the steps ~ in “Entering a
video label” procedure. 2
Correcting or clearing a video label
• Each time the MULTI CONTROL knob is rotated,
the characters change as follows:
Blank ( )
Alphabets: A~Z, a~z
Numerals: 0~9
Symbols: ( ) + , . /
• This function can be operated only on video input
sources such as VIDEO 1~4.
• Then the next digit will flicker.
• On up to 9 digits, the desired characters can be
entered.
Note: If any button such as “AUDIO”, “VIDEO”,
“7.1 CH DIRECT” button, etc. is pressed
while entering a video label, the video label
mode will be canceled.
• To clear a video label, make a blank on each digit
and memorize it, then the video label is cleared and
its factory video input source will be displayed.
• If the VIDEO LABEL button is pressed for more
than 3 seconds, blanks will be made on all the digits
at once.
or
VIDEO
DVD
VOL. CH LEVEL
CH SEL
DSP MODE
AUTO
ST CENTER MODE TEST TONE DISC P.SCAN
TUNER CD T1/MON AUX PHONO
VID1 VID2 VID3 VID4 VID5
SYS DISP SLEEP DIRECT IN ROOM2
INTRO
RETURN
B RPT A
7.1 SURR TITLE
ENTER
VID2 VID1 VID3 VID4
HOME THEATER MASTER RV4700 DTS-ES
or
VIDEO
DVD
VOL. CH LEVEL
CH SEL
DSP MODE
AUTO
ST CENTER MODE TEST TONE DISC P.SCAN
TUNER CD T1/MON AUX PHONO
VID1 VID2 VID3 VID4 VID5
SYS DISP SLEEP DIRECT IN ROOM2
INTRO
RETURN
B RPT A
7.1 SURR TITLE
ENTER
VID2 VID1 VID3 VID4
HOME THEATER MASTER RV4700 DTS-ES
MULTI CONTROL
VIDEO LABEL
VIDEO LABEL
MEMO/ENTER