DTS RV4700 DTS-ES - Manual (Page 8)

8
COMPONENT
Y
MONITOR
VIDEO 2
VIDEO 3
S-VIDEO
VIDEO 1
OUT
IN
VIDEO 1
VIDEO 2
MONITOR
VIDEO 1
VIDEO 2
VIDEO 3
MONITOR
VIDEO 1
VIDEO OUT
IN
ROOM 2
VIDEO 1
OPT 1
OPT 2
COAX1
COAX2
COAXIAL IN
7.1CH DIRECT
INPUT
FRONT
CENTER
SUR- ROUND
SUR- ROUND BACK
FRONT
CENTER
SUR- ROUND
SUB WOOFER
SUR- ROUND BACK
PRE
OUT
SUB WOOFER
R L
R L
AM LOOP
OUT
TAPE
MON.
VIDEO 1
R L
ROOM 2
MULTI
VIDEO 3
CD
AUX
VIDEO 1
VIDEO 2
TAPE MON.
R L
IN
L
FRONT SPEAKERS
SURR. SPEAKERS
SURR.
BACK
SPEAKERS
R
L R
SWITCHED
230V~50Hz
100W MAX
OPTICAL IN
OPTICAL OUT
REC
CAUTION : TO PREVENT ELECTRIC SHOCK, DO NOT REMOVE COVER.
NO USER-SERVICEABLE PARTS INSIDE. REFER-SERVICING TO QUALIFIED
SERVICE PERSONNEL.
SER. NO
AC OUTLET
FM
75
CENTER SPEAKER
FRONT , CENTER , SURROUND, SURROUND BACK : 6 OHMS( ) MIN.
Manufactured under license from
Dolby Laboratories. “Dolby”, “Pro Logic”,
and the double-D symbol are
trademarks of Dolby Laboratories.
Manufactured under license from Digital Theater System, Inc. U.S. Pat. No's.
5,451,942; 5,956,674; 5,974,380; 5,978,762; 6,487,535 and other U.S. and world-wide patents
issued and pending. "DTS" and " DTS-ES" and "Neo:6" are trademarks of
Digital Theater Systems, Inc. Copyright 1996, 2003 Digital Theater Systems, Inc.
All Rights Reserved.
Y
P B/ C B
P R/ C R
Y
P B/ C B
P R/ C R
P B/ C B
P R/ C R
MODEL NO. RV4700 DTS-ES
AUDIO/ VIDEO RECEIVER
DESIGNED IN USA ASSEMBLED IN KOREA
FRONT
CENTER
SUR- ROUND
SUR- ROUND BACK
PRE
OUT
SUB WOOFER
R L
AC INLET 230V~50Hz 370W
ROOM 2 connections
Another room
• This outlet is switched on(power-on mode) and
off(standby mode) according to power control
as follows(Maximum total capacity is 100W):
Standby mode – switched AC outlet off
Power-on mode – switched AC outlet on
SWITCHED AC OUTLET
• If another A/V receiver or integrated amplifier, etc. is connected to these jacks, you can play a different program source
in another room as well as one source in the main room at the same time.(For details, refer to "ROOM 2 SOURCE
PLAYBACK" on page 33).
• When the multi-room adaptor is connected to control this unit in another room, the ROOM 2 function is more convenient.
Note:
• Use high quality connection cords in such a way that there is no humming or noise.
AC INLET
P lug the supplied AC input cord into this AC
INLET and then into the wall AC outlet.
To a wall AC
outlet.
• Do not use an AC input cord other than the
one supplied with this unit. The AC input
cord supplied is designed for use with this
unit and should not be used with any other
device.
• Never short circuit the + and - speaker wires.
• Be sure to connect speakers firmly and correctly according to
the channel (left and right ) and the polarity ( + and -).
• Be sure to use speakers with the impedance of over 6 Ω.
• Only in case of enjoying either 6.1 or 7.1 channel surround
playback, connect only the surround back left speaker or both
of surround back speakers.
Note:
• After installing the speakers, first set the connected speakers to
the desired before operating this receiver.(For details, refer to
"SETTING THE SPEAKER SETUP" on page 36.)
CONNECTING SPEAKERS
Front
right Front
left
Surround
left
Surround
right
Surround
back
right
Front
center
Surround
back
left
MONITOR
VIDEO
OUT
ROOM 2
VIDEO 1
ROOM 2
L
FRONT
SPEAKERS
SURR.
SPEAKERS
SURR.
BACK
SPEAKERS
R
L R
CENTER
SPEAKER
VIDEO IN
AUDIO IN
VIDEO IN
Monitor TV
Speakers
A/V receiver
or amplifier