Daewoo DP-42WM - Manual (Page 17)

17
Input Select
INPUT
SELECT
• Select [Component 1 or Component 2] by
pressing the INPUT SELECT button of the
Remote Control or the PDP unit.
• Each time you press the INPUT SELECT
button, different input modes appear. The
sequence is as follows: Component 1 -->
Component 2 --> Video 1 --> Video 2 -->
PC.
Select a Desired Channel and Function
• Select a desired channel and function by
using the Remote Control of Digital
Broadcasting Receiver.
3
4
NOTES:
1) You can select INPUT SELECT while you are using OSD(Menu).
Sequence: [Menu] --> [Input] --> [Component 1 or 2 (DTV/DVD)]
2) Digital Broadcasting signals available: 1080i(60Hz), 720p(60Hz),
480p(60Hz)
3) Antenna Connection:
Apartment : Check if community antenna receives digital broadcasts.
Private Houses: Set the indoor/outdoor UHF antenna to the direction
of the digital broadcasting transmitting company.
4) For detailed connection method, refer to the Owner’s Manual of Digital
Broadcasting Receiver.
5) What is a component? : Signal with which brightness and color signals
are separated, producing a sharp screen.
6) If the Digital Broadcasting Receiver has PC Output terminal
(D-sub15pin), connect to ‘PC INPUT’ at the back panel of the PDP.
When watching the PDP by PC Input, some undesired signals may be
seen at the top and bottom area of the screen. In this case, select
[Menu] --> [Screen] --> [Vertical Size] to adjust.
Component1
PC
Component2 Video1
Video2