Controls, Mower blade switch, Ignition switch – Dixon 13092-0901 User Manual

Page 17: Choke control lever, Throttle control lever, Circuit breaker

Advertising
background image

17

CONTROLS

MOWER BLADE SWITCH:

To engage blades: pull up on switch

To disengage blades: push down

IGNITION SWITCH:

Turn to start position to crank engine.

Release when it starts.

For headlights - rotate switch one

notch counter-clockwise from run.

Note:

Remove key when mower is

not in use.

CHOKE CONTROL LEVER:

Located on the control panel to the

operator’s right.

THROTTLE CONTROL LEVER:

Located on control panel to operator’s right.

Controls engine speed.

While mowing, throttle control should be set to MAXIMUM or wide

open setting to insure adequate cooling of the engine and to

maintain mower deck blade speed.

CIRCUIT BREAKER:

If circuit breaker pops up, it disconnects the power. Wait 2 minutes

and push to reset.

If it pops up again, there is a short circuit. Stop and find fault or

contact your dealer.

Advertising
This manual is related to the following products: