Troubleshooting – Dixon 13092-0901 User Manual

Page 41

Advertising
background image

41

TROUBLESHOOTING

6.

ENGINE OVERHEATED

Air intake screen or fins clogged- - - - - - - - - - - - - - - - - clean intake screen and fins
Fuel mixture too lean- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - readjust carburetor*
Improper ignition timing- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -consult dealer
Oil level too low or too high- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - adjust oil levell
Running engine too slow- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -run engine faster

(NOTE: Always mow at full throttle setting)

7.

ENGINE SOMETIMES SKIPS AT HIGHER SPEEDS

Incorrect ignition timing- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - consult dealer
Carburetor maladjusted- - - - - - - - - - - - - - - - - - - - - - -- - - - - - - -readjust carburetor*
Faulty spark plug- - - - - - - - - - - - - - - check spark plug or condition and reset gap*

8.

ENGINE RUNS BUT MOWER WON’T MOVE FORWARD

Drive belt broken or slipping- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -replace drive belt
Pump arm loose or disconnected- - - - - - - - - - - - - - - - - - - - - - - -tighten or reconnect
Hydraulic oil system low- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - add oil
By-pass valves in free wheel position- - - - - - - - - - - - - - - - - - - - tighten by-pass valves
Hydrostat oil filter plugged- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - replace filter
Bad pump or wheel motor - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -consult dealer

9.

ENGINE STALLS WHEN BLADES ARE ENGAGED

Operator not on seat- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -sit on seat
Faulty interlock system- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -consult dealer
Bad Blade spindle bearing- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - consult dealer
Deck drive belt not properly routed- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - reroute
Blades blocked by foreign material- - - - - - - - - - - - - - - - - - - - - - - - - -clean under deck

10.

ENGINE BACKFIRES

Carburetor maladjustment- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -readjust carburetor

11.

ENGINE IDLES POORLY

Carburetor maladjustment- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -readjust carburetor
Improper spark plug gap- - - - - - - - - - - - - - - - - - - - - - - - - - - - - check and re-gap plug*

*See engine manual for engine adjustment

Advertising
This manual is related to the following products: