Sea Eagle Stealth Stalker 10 (STS10) - Manual (Page 5)

Floorboards
Locate the floorboards
and aluminum struts
Seat Mounts
(OPTIONAL)
First attach the seat
mounts to the floor-
boards. Locate the 1 ½”
flathead bolts and T-
nuts which are packed
with the seat mounts.
You will need a #2
(medium) or #3 (large)
tip phillips head screw-
driver.
Insert the T-nuts into the
mounting holes in the
floorboard. This will be
the underside of the
board.
Place the seat mount
over the top of the floor-
board holes and screw
the flathead bolts into
the T-nuts.
Scotty Rod Holders
Locate the rod holders
and the 7/8” caphead
bolts (usually located in-
side of the orange re-
pair kit canister).
Remove the mounting
base.
Use the bolts to secure
the mounting base to
the pads glued onto the
boat. Orient the base to
the arrow points in-
board. Do not use bolts
longer than the ones
provided as they could
puncutre the boat.
Swivel Seat/Pedestal
(OPTIONAL)
Bolt the seat to the
pedestal using the 1/2”
bolts and wing nuts.
The hardware is usually
packed with the seat
mount.
Offset the swivel base
so you have enough
room to insert the
screws and tread the
nuts. Tighten the nuts
securely.
4
ONE TIME ASSEMBLY
There are some items that require one time assembly. Once installed they may remain in place when the boat is rolled up after use or
require partial assembly for use. Not all items desecribed below are included with all boat packages.