Sierra Video MFC-8300 - Manual (Page 38)

6-2
• DashBoard Menus
MFC-8300 Series User Manual (Ver. 1.0)
Status Tabs
Table 8.1 summarizes the Status tab parameters available in DashBoard for the MFC-8300 Series
Controller Cards. The Status tabs provide read-only information such as software revision issue, fan
door status, and power consumption.
Table 6.1 Status Tab Items
Tab Title Item Parameters Description
Product
(Read-only)
Frame Name
Name as defined by the user in the Network
tab. Refer to Table 6.4.
Frame S/N a Indicates the Frame Serial Number.
Product Indicates the model number of the card
Supplier Sierra Video
Board Rev ## Indicates the hardware revision
Board S/N ######-### Indicates the card serial number
MAC Address ##-##-##-##-##-## MAC Address for the card
Software Rev #.## Indicates the card software version
Network
(Read-only)
Network Source
DHCP - set by user
SW3-1 and SW3-2 are set to OFF; the
Addressing Mode is set to DHCP in
DashBoard. The network automatically
assigns the card ethernet settings.
Static - set by user
SW3-1 and SW3-2 are set to OFF; the
Addressing Mode is set to Static in
DashBoard. User defines the ethernet
settings from the Network tab.
DHCP - set by DIP
SW3-1 is set to OFF and SW3-2 is set to
ON. The network automatically assigns the
card ethernet settings.
This is not applicable to the MFC-8320-S.
Factory Default 1
SW3-1 is set to ON and SW3-2 is set to
OFF. The IP Address of the card is set to
192.168.2.1. This is not applicable to the
MFC-8320-S.
a When installed in a DFR-832x series frame only.